n
Pro Mag 44 Kill Switch
Having a kill switch for the ignition system is mandatory in racing organizations and to kill the power of a Pro Mag 44, you need a strong switch. The MSD Air Kill Switch is the only switch MSD recommends for the Pro Mag 44.
This air actuated switch will effectively kill the power to two Pro Mag 44 systems through a manually operated switch mounted in the cockpit.
Note: Air tank and line are required.
Pro Mag 44 Air Kill Switch PN 8101
This heavy duty Single-Pole Single-Throw switch will stand up to the abuse of the racing world. The Switch is rated at 15 amps so it can handle the power of the Pro Mag 12. The housing is designed to survive high impacts and features a molded-in elastomer seal between the toggle lever and bushing. The beefy aluminum housing provides a secure mount to withstand extreme racing conditions. (Supplied with the PN 8105 and PN 8106 Electronic Points Boxes.)
Note: Not for use with the Pro Mag 44
SPST Kill Switch, 12 Amp Mag Only PN 8111
In many racing classes, there must be one kill switch for the ignition. If you are running a dual Pro Mag setup on your car, this is the switch you need. This Double-Pole, Single-Throw switch is designed to handle the abusive world of drag racing and other severe applications. An elastomer seal prevents debris from entering the strong aluminum housing.
Note: Not for use with the Pro Mag 44.
DPST Kill Switch, 12 Amp Mag Only PN 8115
MSD Deutsch connectors are used on all of the Pro Mags and their accessories. Each housing is indexed to prevent mismatching the terminals and are molded from a durable plastic material that will not harden over time. The terminals grip to the wire with strong crimp tabs then lock into position inside the housing. The connectors are protected with thick seals that will keep water, mud and debris away from the contacts. The Deutsch terminals also handle more current than conventional connectors and do not require special tools to disassemble. Each Connector is supplied with the terminals, seals and housings.
2-Pin Connector PN 8183
4-Pin Connector PN 8181
6-Pin Connector PN 8180
8-Pin Connector PN 8185These Pro Mag Wiring Repair Kits are designed to be used for emergency wiring fixes while at the races. Both Kits are supplied with the strain relief that mounts to the generator, wires, two 4-Pin connectors and screws.
(It is recommended to send the unit in for complete wiring repairs when required.)
Wire Repair Kit
12 Amp Pro Mag Only PN 8124
Wire Repair Kit
44 Amp Pro Mag Only PN 8125no photo
If your application leaves the Mag cables short of reaching the Electronic Points Box, these extension harnesses should do the trick. Both feature matching connectors and wiring for their application.
12 Amp Mag
Three Feet PN 8112
44 Amp Mag
Two Feet PN 8143
