Installation Instructions

You will need Acrobat Reader to view files, download it here

Programmable Shift Controller
PN 75591

MSD A Fuel Dual Pro Mag
PN 8973

MSD Pro-Mag 44 Kill Switch Relay
PN 8134

MSD Pro-Mag to EFI Installation

MSD Crank Trigger to Generator Cross-Over Switch
PN 7990

Pro Mag Digital Retard Controller-Digital Controller Graphic Editor
PN 8971 - PN 7570

PN 7531 Programmable Digital 7-Plus to Pro Mag
Addendum to 7531
PN 7531

Installing 3 Six Shooters
PN 8158

Pro Mag Digital Retard Controller and Digital Controller Graphic Editor
PN 7570, PN 8971

MSD Programmable Pro Mag Controller
PN 8973

MSD Pro Mag 12 Amp Generators
All Models

MSD Pro Mag 12 LT (Chevrolet, Ford, Chrylser)
PN 7908, PN 7915, PN 7910

MSD Pro Mag 12 Amp Electronic Points Box
PN 8105, PN 8106

MSD Pro Mag 44 Amp Generator
PN 8130, PN 81401

MSD Pro Mag 44 Electronic Points Box
PN 8145, PN 8147

MSD Pro Mag Timing Control
PN 8168

MSD Six Shooter Module Selector
PN 8158

MSD Pro Mag 44 Coil
PN 8142

MSD Pro-Cap
PN 7455

MSD Pro-Battery Pack and MSD Smart Charger
PN 8162, PN 8161

MSD Sprint Car Crank Trigger Parts and Accessories
PN 7971, PN 7980, PN 7981, PN 7975, PN 7976, PN 7977

MSD Crankshaft Hub, Installation/Removal Tool
PN 7992 (For MSD Sprint Car Crank Trigger Systems)

MSD Sprint Car Crank Trigger
PN 7950, PN 7955, PN 7960, PN 7965, PN 7970

MSD Pro Mag Tach Converter
PN 8132

Typical 44 Amp System w/Six Shooter and Retard Ground Path

Pro Mag Programming Tester
PN 8993

GraphSave is a windows based application used to view, modify and save user data for all MSD digital programmable products transferred from the hand held 7570 Graphic Editor via the serial port. A mouse is required to fully apply all features and functionality of the GraphSave Software. Note: For firmware version 7570v1 download GraphSave 1.02, for versions later than 7570v1 download GraphSave 1.08 To determine the version fo the firmware follow the steps below: Turn the MSD 7570 product ON The top right hand corner of the display screen will display the version of firmware loaded on the product. Note: This will ONLY appear for about 5 seconds. Turn the product OFF, then ON again if you fail to view the correct version of the firmware. Click here to download GraphSave version 1.02 900 kb Click here to download GraphSave version 1.09 1.4 mb Click here to download Pro-Data+ version 3.19 12 mb